Gantry over-travel specifications, Figure 5-45 – Adept Python User Manual
Page 101
Gantry Mounting Kits
Adept Python Modules User’s Guide, Rev. E
101
Figure 5-45. Gantry Installation: Lip Seal to Support Bracket Gap Dimensions
Gantry Over-Travel Specifications
The LG6 gantry support module is designed with approximately 45 mm more travel than
the X-axis module. This provides flexibility in axial mounting locations. The X-axis
module hardstops should always limit the module system travel, not the gantry support
module. See
NOTE: You must verify that the gantry support over-travel requirements
are within specification. If not, the life of the module system could be
greatly reduced.
1 mm ± 0.25
A
Note: the dimension between the
lip seal and the gantry support
bracket must be within the
specified tolerance, or binding
can occur during travel.
Gantry Support
Module
Gantry Support
Module
Lip Seal
Module Mounting
Block
Gantry
Support
Bracket
DETAIL A
Vertical Module
Table