IEI Integration UPC-12AH_GM45 v1.00 - Manual (Page 99)

UPC-12A/GM45 Panel PC
Page 87
Î
COM1 D EFAULT
System is remotely accessed through COM1
Î
COM2 System is remotely accessed through COM2
Î
COM3 System is remotely accessed through COM3
Î
COM4 System is remotely accessed through COM4
NOTE : Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Î Base Address, IRQ [3F8h,4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
Î Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available
„ 115200 8,n,1 D EFAULT
„ 57600 8,n,1
„ 38400 8,n,1
„ 19200 8,n,1
„ 09600 8,n,1
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
Î Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.