IEI Integration UPC-12AH_GM45 v1.00 - Manual (Page 66)

UPC-12A/GM45 Panel PC
Page 54
Step 5: Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel (
566H566H
Figure 4-21 ).
S te p 0 :
Figure 4-21: Tighten the Panel Mounting Clamp Screws
4.11.3 Arm Mounting
The flat panel PC is VESA (Video Electronics Standards Association) compliant and can
be mounted on an arm with a 100 mm interface pad. To mount the flat panel PC on an arm,
please follow the steps below.
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.