IEI Integration UPC-12AH_GM45 v1.00 - Manual (Page 61)

UPC-12A/GM45 Panel PC
Page 49
4.11 Mounting the System
WARNING:
When mounting the flat panel PC onto an arm, onto the wall or onto a
panel, it is better to have more than one person to help with the
installation to make sure the flat panel PC does not fall down and get
damaged.
The four methods of mounting the flat panel PC are listed below.
„ Wall mounting
„ Panel mounting
„ Arm mounting
The four mounting methods are described below.
4.11.1 Wall Mounting
To mount the UPC-12A/GM45 flat panel PC onto a wall, please follow the steps below.
Step 1: Select the location on the wall for the wall-mounting bracket.
Step 2: Carefully mark the locations of the four bracket screw holes on the wall.
Step 3: Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 4: Align the wall-mounting bracket screw holes with the pilot holes.
Step 5: Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (
561H561H
Figure 4-16 ).