IEI Integration UPC-12AH_GM45 v1.00 - Manual (Page 87)

UPC-12A/GM45 Panel PC
Page 75
Î
Compatible D EFAULT
Configures the on-board ATA/IDE controller to be in
compatible mode. In this mode, a SATA channel will
replace one of the IDE channels. This mode supports
up to 4 storage devices.
Î
Enhanced Configures the on-board ATA/IDE controller to be in
Enhanced mode. In this mode, IDE channels and SATA
channels are separated. This mode supports up to 6
storage devices. Some legacy OS do not support this
mode.
Î Configure SATA as [IDE]
Use the Configure SATA as option to configure SATA devices as normal IDE devices.
Î IDE D EFAULT
Configures SATA devices as normal IDE device.
Î RAID Configures SATA devices as RAID device.
Î AHCI Configures SATA devices as AHCI device.
Î IDE Master and IDE Slave
When entering setup, BIOS auto detects the presence of IDE devices. BIOS displays the
status of the auto detected IDE devices. The following IDE devices are detected and are
shown in the IDE Configuration menu:
„ Primary IDE Master
„ Primary IDE Slave
„ Secondary IDE Master
„ Secondary IDE Slave
„ Third IDE Master
„ Fourth IDE Master
„ Fifth IDE Master
„ Fifth IDE Slave