IEI Integration UPC-12AH_GM45 v1.00 - Manual (Page 95)

UPC-12A/GM45 Panel PC
Page 83
Î
Disabled No base address is assigned to serial port 3
Î
3E8 Serial port 4 I/O port address is 3E8
Î
2E8 D EFAULT Serial port 4 I/O port address is 2E8
Î Serial Port4 IRQ [10]
Use the Serial Port4 IRQ option to select the interrupt address for serial port 4.
Î
10 D EFAULT
Serial port 4 IRQ address is 10
Î Select RS232 or RS422/RS485 [BY HARDWARE]
Use the Select RS232 or RS422/RS485 option to select the Serial Port 4 signaling mode.
Î
RS232 Serial Port 4 signaling mode is RS-232/422
Î
RS422/RS485 Serial Port 4 signaling mode is RS-485
Î
BY
HARDWARE
D EFAULT
Serial Port 4 signaling mode is set by onboard jumper
6.3.4 AHCI Configuration
NOTE:
Advanced Host Controller Interface (AHCI) is a new programming
interface for SATA host controllers. AHCI systems do not have
master/slave designation for SATA devices, each device is treated as a
master, and hardware-assisted native command queuing.
Use the AHCI Settings menu (
603H603H
BIOS Menu 7 ) to report on the auto-detection of devices
connected to the onboard SATA drive connectors.