Furuno FS-5070 - Manual (Page 81)

5. ROUTINE MESSAGE CALLING, RECEVING
5-21
2. Press the CANCEL key to go to the radiotelephone screen. Watch on the working
frequency specified by radiotelephone or NBDP. If there is the difference between the
registered frequency and used frequency to receive, the following screens appear.
Choose Agree for the voice communication, or Disagree when you do not change the
frequency.
After 10 seconds passed or when "Agree" is chosen,
the working frequency is changed with the message
shown below.
Choose "Pause".
Accept New
Working Freq
CANCEL: CLOSE WINDOW
Choose "Agree".
Change COM Frequency
Agree Disagree
Count down has been paused.
Change COM Frequency
Agree Disagree
Count down xx sec. Pause
Receiving message by NBDP Terminal Unit
After receiving a neutral craft call, confirm the following.
The control unit’s display shows “OCCUPIED” and the Tx and Rx frequencies.
The message from the sending station appears on your NBDP Terminal Unit.
5.5 Medical Transport Call
The medical transport call informs all ships, by urgency priority, that own ship carries
medical supplies. The medical call is enabled/disable with the Setup menu setting. See
section “6.15 Special Messages”.
5.5.1 Sending a medical transport call
1. Press the 2/DSC key.
Select Message
PSTN MESSAGE
TEST MESSAGE
GROUP MESSAGE
AREA MESSAGE
POSITION
RELAY AREA
RELAY COAST
DISTRESS
SPECIAL
INDIVIDUAL
GENERAL DISTRESS
MMSI 123456789
POS 12 34.5678N
123 45.6789E
UTC 01:53
EPFS 01:54
2. Rotate the ENTER knob to choose SPECIAL and MEDICAL in order and then push the
ENTER knob. PRIORITY is automatically selected to URGENCY.