Furuno FS-5070 - Manual (Page 78)

5. ROUTINE MESSAGE CALLING, RECEVING
5-18
1. Press the CANCEL key to silence the alarm. “Change COM Frequency” display appears,
and the display changes as below.
* Received message *
MAR-23-2006-23:59
GEOGRAPHICAL AREA
SENDER ID : 123456789
PRIORITY: SAFETY
TELEPHONE: 2182.0 kHz
GO TO VIEW
10M10S
3. Press the CANCEL key to go to the radiotelephone screen. Watch on the working
frequency specified in the geographic area call. If there is the difference between the
registered frequency and used frequency to receive, the following screens appear.
Choose Agree for the voice communication, or Disagree when you do not change the
frequency.
After 10 seconds passed or when "Agree" is chosen,
the working frequency is changed with the message
shown below.
Choose "Pause".
Accept New
Working Freq
CANCEL: CLOSE WINDOW
Choose "Agree".
Change COM Frequency
Agree Disagree
Count down has been paused.
Change COM Frequency
Agree Disagree
Count down xx sec. Pause
Receiving message by NBDP Terminal Unit
After receiving a geographic area call, confirm the following.
•The control unit’s display shows “OCCUPIED” and the Tx and Rx frequencies.
•The message from the sending station appears on your NBDP Terminal Unit.