Furuno FS-5070 - Manual (Page 70)

5. ROUTINE MESSAGE CALLING, RECEVING
5-10
DSC FREQ: 4 M-INTL
STATION ID: 121234567
COMM FREQ: CH401
MSG TYPE: ABLE
ACKNOWLEDGEMENT
Compose msg.
GO TO VIEW
COMM MODE: TELEPHONE
5. Press the CALL key to send the acknowledge call. The display changes as below.
Able acknowledge
message in progress!
TIME TO GO: 7S
DSC FREQ : 4208.0 kHz
DESTINATION ID : 121234567
PRIORITY : ROUTINE
TELEPHONE CH 401
6. After the call is completely sent (transmission time: 7 sec.), push the CANCEL key twice
to show the radiotelephone screen (if the communications mode is telephone).
7. You can begin voice communications by radiotelephone. For NBDP operation, do the
following:
Communicating by NBDP Terminal Unit
After acknowledging an individual call, do the following to communicate by NBDP Terminal
Unit. The control unit’s display shows “OCCUPIED” and the Tx and Rx frequencies. The
message from the other party appears on your NBDP Terminal Unit.
1. After receiving the message from the other party, type your message and transmit it.
2. Press the function key F10 (BREAK) to disconnect the line.
Manually acknowledging individual call with “UNABLE”
When an individual call is received and the equipment is set up with manual acknowledge,
the alarm sounds and the display shows the message “Individual xxx (priority name)
message received.”
Individual routine
message received.
TELEPHONE CH 401
Ack Required.
CANCEL: STOP ALARM
1. Press the CANCEL key to silence the alarm. The display changes as below.