Furuno RC-1500-1T - Manual (Page 281)

1-13
5. Press [ ] to select OFF..
Note: To silence the audible alarm given to an EGC distress or
urgent message from Distress Alert Unit (IC-302), follow
the above procedure. DO NOT press the DISTRESS button
on the IC-302 to silence the alarm; you will transmit own
ship’s distress alert.
6. Press [Enter] to close the selection window.
7. Press [Esc] twice.
Using a Personal Computer as a Terminal Unit
PC requirements
Applicable PC: Toshiba T-2110 or IBM-AT compatible
Memory required: 640K bytes
Graphics: Any one of CGA/EGA/VGA
Disk Drive: One 2HD
Operating System: MS-DOS Version 3.0 or later
Installing the program
Make the directory "FELCOM12" on the hard disk (drive C) and
install the program there as follows;
1. Go to the MS-DOS prompt.
2. Insert the program disk (supplied) in drive A.
3. Type " A: " and press [Enter].
4. Type " PCRINST " in case of main DTE and press [Enter]. The
directory MAIL (default directory), where receive messages are
automatically saved, is automatically made. To save receive
messages to a different directory, use the RD command to
delete the MAIL directory. (See "Setting Directories" on page
2-27.)
Type "
PCRINST 2" in case of 2nd DTE press [Enter].
5. To install Russian software, type " PCRINST " and press [Enter].
(Russian and English may be switched by pressing left [SHIFT]
with lift [CTRL] and left [ALT] .)
6. Turn off the power.
7. Turn on the power.
8. Confirm that the software starts up properly.
Note: You need 128KB (or more) of extended memory in RAM.
De-designate extended memory filer (such as HIMEM.SYS) in
config.sys file, when extended memory in used.