Furuno RC-1500-1T - Manual (Page 106)

4-30
10. After the call is sent (timer counts down to zero) the following display appears.
Waiting for polling
acknowledgement.
DSC FREQ : 2177.0 KHZ
TIME TO GO: 4M59S
FROM SHIP: 123456789
ROUTINE
11. The timer counts down the time remaining to wait for acknowledgment of the call. One of the
following displays appears. (“No response! Try calling again?” appears when there is no
response from receiving station; timer counts down to zero.)
No response!
Try calling again?
DSC FREQ : 2177.0 KHZ
FROM SHIP: 123456789
ROUTINE
Polling acknowledge
call received.
FROM SHIP : 123456789
ROUTINE
NO INFORMATION
STOP ALARM CALL AGAIN
Polling acknowledge
call received
No response
12. Do one of the following depending on the message shown in step 11.
Polling acknowledge call received
The audio alarm sounds; press the [CANCEL] key to silence the alarm. The display changes as
below. You can confirm if called party is within communicating range.
JUL-23-1999-23:59 ECC: OK
POLLING ACKNOWLEDGE
FROM SHIP: 123456789
ROUTINE
NO INFORMATION
* Received message *
GO TO ALL VIEW
No response! Try calling again?
Re-send call: Press the [ENT] key (the display shown in step 8 appears), followed by the [CALL]
key to re-send the call.
Cancel call: Press the [CANCEL] key to return to the DSC standby screen.