Furuno RC-1500-1T - Manual (Page 116)

4-40
5. Press the [ENT] key to open the TEL NO. menu.
GO TO ALL VIEW
*** Send message ***
CALL TYPE:
COAST ID
DSC FREQ
PSTN CALL
: 001234567
:12M-INTL
----------------
TEL NO.
How to input telephone no. automatically
If you have registered some coast IDs (Chapter 6),
you can insert them into your message as follows:
1. Press the [FILE] key after completing step 4 in the
above procedure. The following display appears.
2. Select file which contains no. you want to use
(press
"
to show ID number).
3. Press the [ENT] key to insert no. in message.
Telephone no. file
300. FURUNO
"
500. MARINE "
777. ELECTRIC
"
Note: You can print the
Telephone no. file list by
pressing the [8/PRINT] key.
# UP $ DOWN
6. Enter telephone no. (16 digits max.) and press the [ENT] key.
7. Press the [ENT] key to open the DSC FREQ menu.
GO TO ALL VIEW
*** Send message ***
CALL TYPE
COAST ID
: PSTN CALL
: 123456789
TEL NO. : 123456789012345
DSC FREQ :12M-INTL
6 MHz
8 MHz
$
12 MHz
4 MHz
2 MHz
16 MHz
18 MHz
22 MHz
25 MHz
#
OTHER
MANUAL
Use
$
to scroll
menu.
OTHER: Special, private channel
MANUAL: Manual tuning of
radiotelphone
8. Select DSC band and press the [ENT] key. Select DSC frequency and press the [ENT] key.
The display changes as below.
*** Send message ***
DSC FREQ : 12577.5 KHZ
GO TO ALL VIEW
CALL TYPE : PSTN CALL
COAST ID : 001234567
TEL NO. : 1234567890123456
9. Press the [CALL] key to send the PSTN call (transmission time: about 7 sec.). The display
shows the following message.
PSTN request
call in progress!
TIME TO GO: 7S
TO COAST : 001234567
TEL NO. : 1234567890123456
DSC FREQ : 12577.5 KHZ
10. One of the following three displays appears. (“No response. Try calling again.” appears if
there is no response from the receiving station - the timer counts down to zero.)