Furuno RC-1500-1T - Manual (Page 176)

2-2
2.2 Turning on the System
There is no particular order for turning on the units of the system.
The figure below shows the location of power switches on the units
of the system. Note that it takes about six seconds for the LCD to
light after the power is turned on.
POWER switch
POWER switch
POWER switch
TERMINAL UNIT
MAIN UNIT
PRINTER
Figure 2-2 Main unit, terminal unit and printer
2.3 Equipment Description
Terminal Unit
The terminal unit consists of a 9" visual display, a floppy disk drive
and a keyboard. The floppy disk drive provides for unlimited stor-
age of files on floppy disks. Controls for power and adjustment of
display brilliance and contrast are provided on the front panel.
When the terminal unit is turned on the communication status dis-
play appears. This is where all phases of communication begin.
Station Name :
Frequency (T/R) : / (kHz) Comm Mode : Auto
Comm Status : Connect Send Lock Error
Sending Volume : (%) ARQ Error : 0 ARQ Time : 0(sec)
1:File 2:Edit 3:Operate 4:Window 5:Station 6:System 7:WRU 8:HR 9:Over 10:Break
1996-11-15 13:26:45:45 Caps Eng
Figure 2-3 Communication status display