HP VECTRA VL800 - Manual (Page 40)

2 Installing and Replacing Hardware Parts in Your PC
Replacing the Hard Drive Bay and Speaker Assembly
40
7 From the front of the PC: (a) push the two plastic clips located on the
left-hand side inwards; (b) repeat this procedure for the other two clips
on the right-hand side.
8 Unclip the retention clip located on the right-hand side and middle of the
hard disk drive bay and speaker assembly.
9 Slide the hard disk drive bay and speaker assembly towards the system
board until it is well clear of the chassis edge (located between the hard
disk drive bay and speaker assembly and front access cage).
10 Lift the hard disk drive bay and speaker assembly upwards to remove it
from the computer.
Replacing the Assembly
1 Ensure that there are no cables underneath the hard disk drive bay and
speaker assembly.
2 Align the two plastic tabs (control panel side) of the hard disk drive bay
and speaker assembly with their associated notches.
➒
b a
Retention clip