Heat & Glo Fireplace Heat & Glo Fireplace 6000C - Manual (Page 57)

Heat & Glo • 6000C, 6000C-IPI, 8000C, 8000C-IPI • 2164-900 Rev. T • 9/12 57
Figure 13.4 Finishing Material 1 Inch Thick or Less
DOOR FIT
FINISH MATERIAL
THICKNESS
SEE
FIGURE
Folio Inside Any 13.6
Arcadia
Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
Halston
Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
Chateau
Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
MT Hammer
Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
Galleria
Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
CF Inside Any 13.6
DOOR
1 in. MAX.
FINISHING MATERIAL
(TOP EDGE)
Finishing materials 1 inch maximum thick.
Stop finishing material flush with opening.
FINISHING STRIP NOT USED
(See Figure 13.7 for
removal instructions)
NON-COMBUSTIBLE
FINISHING MATERIAL
Note: Finishing strips may be used to aid in positioning of
non-combustible facing materials for some of the facing and
door combinations specified in the table above. They must
be removed following finishing work. See figure 13.7.
C. Doors
Only doors certified for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used. Once you have determined what kind of door
and finishing material is going to be used on the fireplace,
you may use the table below which shows the door mod-
els and the finishing material thickness allowed.
Finishing Material:
1 Inch Thick or Less
Remove Finishing Strips. See Figure 13.7.
NOTICE: Remove finishing strips before firing appliance.