HP Officejet 6000 - Manual (Page 18)

2 Install the accessories
This section contains the following topics:
• Install the duplexer (available on some models)
• Turn on accessories
Install the duplexer (available on some models)
You can print on both sides of a sheet of paper automatically when the optional automatic
two-sided printing accessory (duplexer) is installed. For information on using the
duplexer, see
Print on both sides (duplexing) .
Install the duplexer
1. Push the buttons on the rear access panel and remove the panel from the device.
2. Slide the duplexer into the device until the unit locks into place. Do not press the
buttons on either side of the duplexer when installing the unit; use them only for
removing the unit from the device.
Turn on accessories
This section contains the following topics:
• Activate and deactivate the duplexer on the device
• To turn accessories on or off on Windows computers
• To turn on accessories on Macintosh computers
Activate and deactivate the duplexer on the device
When you install or remove the duplexer, you need to activate or deactivate the accessory
on the device control panel.
To activate or deactivate the duplexer
▲ Press and hold Cancel button and Network button for five seconds. After you
release the buttons, the device will print a report letting you know that the duplexer
has been activated.
14 Install the accessories