Programming the device code – HP MediaSmart SLC3760N User Manual
Page 54
42
HP MediaSmart HDTV User’s Guide
Programming the device code
Use the following steps to program a device button if
your brand is listed.
1
Locate the brand of your device and
manufacturer’s codes (see listings in
“Manufacturer’s codes” on page 44).
2
Turn on the TV. Turn on the device you would like
to program.
3
Press Device button on the remote control as
needed to select AUD, STB, or DVD that you want
to program.
4
Hold down Device button on the remote control
for 5 seconds until the device light blinks, and
then release the device button. The device light
blinks one more time and then remains lit
indicating the remote control is in programming
mode.
5
Enter the first four-digit code. If the code is
accepted, the device light flashes twice. If the
code is not accepted, the device light flashes three
times.
6
Aim the remote control at the device, and press
the Power button once. The device should turn off.
If it does not respond, repeat steps 4 and 5, trying
each code for your brand until you find one that
works. If it still does not work, try searching for the
code using auto setup mode; see “Programming
the device code using auto setup mode” on
page 43.
7
Repeat steps 1 through 6 for each device you
want to control with the remote control.
n
Read all the steps completely before
proceeding. Highlight or write down the
codes and device you wish to program
before performing step 4. If your
Manufacturer is not listed, your device
cannot be programmed into this remote
control.
n
If the device light did not blink twice, then
repeat steps 4 and 5, entering either the
same code or the next code, if available.
!
■
Enter code 9, 9, 9, 9 to reset the selected
device to the factory default
manufacturer value.
■
Enter code 1, 1, 1, 1 to enter auto setup
mode; see “Programming the device
code using auto setup mode” on
page 43.
■
Pressing the 1, 3, and 0 buttons on the
remote control at the same time resets all
three programmable devices to factory
values.
n
If the device does not have a Power button,
press Play.