Harrison Labs MIXBUS V2.0.2 - Manual (Page 16)

Track Name
Click to rename and other utility functions.
Input Selector
Click to select input for the track from sound card
or app.
Plug-in Controls
Controls from the plug-ins can be mapped here for
quick access. The number of control slots avail-
able depends upon the resolution of the computer
screen. A higher resolution will yeld more slots.
EQ Section
3 Band EQ - The lighted button at the top left
enables or disables the EQ. Each band has +/- 15
dB of boost or cut with a sweepable center fre-
quency.
High Pass Filter (HPF) - 12 dB/oct filter with a
Frequency range of 20Hz to 1kHz.
Master Assign (MSTR) and Pan
Click MSTR button to assign this signal directly to
the master channel. Pan control adjusts Left/Right
image (Mix Buses and Master Bus). Pan is
“balance” for stereo inputs.
Mute, Solo, and Track Slate
Displays the track name and values as knobs are
adjusted. Use Track Name to change the slate.
Ctrl/Cmd+click on slate to change channel width
between narrow/wide in the mixer window.
Input Trim
The input trim knob can adjust the input level with
+/-20dB of gain.
Fader Automation
Allows the user to select the fader automation
mode – Manual, Play, Write or Touch.
Fader Level Display
Fader level can also be set by entering a value.
Mix Group (Grp) and Meter Controls
The Grp button allows faders to be assigned to Mix
Groups which link fader, solo, and mute controls.
The meter point button selects between input, pre-
fader and post-fader.
8 8..0 0 IIn np pu ut t C Ch ha an nn ne ells s
16 Section 8.0 - Input Channels Mixbus User Guide
Record Button
Click to arm/disarm the track for recording.
Polarity Invert Button
Click to invert the polarity of the signal.
Pre- and Post-fader redirects
Right-click here to add or remove redirects.
Redirects may be sends, insert paths, or plug-ins.
Redirects positioned above the “---Fader---” are
pre-fader and those positioned below are post-
fader.
Mix bus Sends
Each send may be enabled or disabled with the
lighted button. The level of each send is
adjustable from -90 to +15 dB. Note: Mixbus
sends are post-fader and post-pan.
Compressor Section
There are 5 controls for the Harrison channel com-
pressor: The lighted button enables/disables the
compressor. A triangular slider next to the fader
adjusts the threshold of the compressor. The
“speed” knob adjusts attack/release time. A knob
for make-up gain is provided. The Mode selector
(“L”) may be one of 3 selections: Level, Compress,
or Limit. These modes accommodate the most
common compression techniques. The bar to the
right of the threshold slider shows gain reduction in
red.
Peak Meter
A single bar is shown for Mono channels, dual bars
for stereo.
Peak Hold Value
Double-click on the peak hold value to clear it.