Henny Penny PRESSURE FRYERS 600 - Manual (Page 39)

Model 500/600
1207 3-15
3-6. REGULAR MAINTENANCE
SCHEDULE
Procedure Frequency
Filtering of shortening Every 3 to 6 frying cycles
Filter pump problem prevention As required
Changing of shortening As required
Changing the filter envelope As required
Cleaning the frypot Before changing the shortening
Cleaning the deadweight valve Daily
Night closing procedures Daily
Check optional rinse hose Weekly
for deterioration
Reversing the lid gasket Quarterly
Lid lubrication Quarterly
Limit stop adjustment Quarterly
Check tightness of spreader bars Quarterly
Clean safety relief valve Annually
The filter pump motor is equipped with a manual reset button,
located on the rear of the motor, in case the motor overheats. Wait
about 5 minutes before attempting to reset this protective device to
allow motor to cool. The filter motor is on the rear of the fryer. It
takes some effort to push the reset, and a screwdriver can be used to
help reset the button.
Electric fryers with serial numbers of HB013JB & below, and gas
fryers with serial numbers of GA085JB & below, can push the reset
button, by removing the access panel on the left side panel of the unit.
To prevent burns caused by splashing shortening, turn
the unit’s main power switch to the OFF position before
resetting the filter pump motor’s manual reset protection
device.
3-7. FILTER PUMP
MOTOR
PROTECTOR-
MANUAL RESET
As in all food service equipment, the Henny Penny pressure fryer does
require care and proper maintenance. The table below provides a
summary of scheduled maintenance.