beautypg.com

Model 743 removal, Tools required, Preliminary requirements – HP Model 743 PC User Manual

Page 74: Removing a model 743, Model 743 removal 3-10

background image

3-10

Typical Installation in a VME Card Cage

Model 743 Removal

Model 743 Removal

Tools Required

Model 743 removal requires the following tools:

Preliminary Requirements

Perform the following procedure before you remove the board computer
from the VME card cage:

1 Read the steps in “Turning Off the System,” in Chapter 5.

Removing a Model 743

Follow these steps to remove the Model 743 from a VME card cage:

1 Loosen the captive screws at each end of the board computer that hold the

computer in the VME card cage (in Figure 3-1, the screws are labeled 1
and 2 for a single slot board computer, or 1 through 4 for a dual slot board
computer).

2 Pull both ejector levers out until the board ejects from the card cage.

Tool

Used For

Static grounding wrist strap

Preventing static discharge problems

Light-duty flat-tipped screwdriver

Loosening card cage screws