HP Model 743 PC - Manual (Page 48)

2-10
Accessories Installation
GSC Mezzanine Cards
GSC Mezzanine Cards
Installing GSC Mezzanine Cards
This section provides step-by-step instructions for installing GSC mezzanine
cards into your Model 743.
Preliminary Requirements
Perform the following steps before you install a GSC card:
1 The Model 743 must already have a GSC expansion kit installed.
2 If the Model 743 board computer is already installed in your system card
cage, you must remove it. See Chapter 3 of this book for instructions on
removing and replacing the Model 743 board computer from its chassis.
3 Place the Model 743 board computer on a static free mat on a clean, level
surface.
GSC Mezzanine Card Installation
Follow these steps to install a GSC card into your Model 743 Board Com-
puter:
1 Working from the back of the Model 743 Board Computer, you can install
GSC graphics cards into either the right-hand or center position shown in
Figure 2-4.
2 Using Figure 2-4 as a guide, position a card and line up its connector over
the GSC connector on the board computer.
3 Press the card down to seat the connectors.
4 Insert the two M2.5x6 screws that hold the GSC card to the adapter fixture
and screw into place.
5 Insert the two M2.5x5 screws that hold the card to the front panel expan-
sion plate and screw into place.