HP Model 743 PC - Manual (Page 53)

2-15
Accessories Installation
PMC Bridge Adapter and Expansion Adapter
Figure 2-6 Installing a PMC Card onto the Bridge Adapter
If you are installing only the bridge adapter, go on to step 11. If you are also
installing the expansion adapter, continue with step 4.
4 Refer to your PMC card installation manual, and set any configuration
switches or jumpers that may be required for your application.
5 On the PMC expansion adapter, remove the bezel blank(s) from the sites
where you will be installing the PMC card(s). See Figure 2-7.
NOTE: When installing a PMC card, ensure that the O-ring type gasket near the bezel
remains in place.
6 Install PMC card(s) onto the expansion adapter by aligning the front of the
card with the front bezel, and the rear of the card with the connectors and
Site 1
Site 2
O-Ring Gasket
Bridge Adapter
PMC Card
Bezel
blank