Accessory card slots, Universal agp pro slot – HP XU800 User Manual
Page 30
30
2 System Board
Accessory Card Slots
Accessory Card Slots
The following block diagram shows the position of the accessory card slots
on the system board.
Universal AGP Pro Slot
The Universal AGP Pro (Accelerated Graphics Port) bus, provides
a high-performance graphics interface. It uses a 66.6 MHz base
clock, and provides a peak bandwidth of 1064 MB/second in AGP
4x mode.
The Universal AGP Pro slot is a Universal-type connector which
provides power through 3.3 V, 12 V or 5 V power rails with a
maximum allocated power consumption of 50 W.
The Universal AGP Pro slot supports AGP 1x and 2x modes (uses 3.3 V or
1.5 V signals), and AGP 4x mode (1.5 V signalling is required).
Three 32-bit 33 MHz PCI slots:
PCI Slot 1,
PCI Slot 2,
PCI Slot 5
(PCI Slot 2) - J14
(PCI Slot 1) - J15
(PCI Slot 3) - J13
(PCI Slot 4) - J12
One Universal AGP Pro slot.
Used for a graphics controller.
Two 64-bit 66 MHz PCI slots:
PCI Slot 3,
PCI Slot 4
(Universal AGP Pro Slot) - J22
(PCI Slot 5) - J11
System board edge
AGP Video Card
1
1.
AGP Pro video cards are supported up to 50 W.
Supported
operation in the
Universal AGP Pro
Slot
1.5 V
Universal
3.3 V
≤
25 W
≤
50 W
≤
25 W
≤
50 W
≤
25 W
≤
50 W
AGP1x
2
2.
With or without sideband addressing.
yes
yes
yes
yes
yes
yes
AGP2x
2
yes
yes
yes
yes
yes
yes
AGP4x
2
yes
yes
yes
yes
no
no
PCI-type
yes
yes
yes
yes
yes
yes