Hoshizaki KM-151BAH - Manual (Page 58)

53
7) Put the Float Switch down into the mounting hole and hook it in position as shown.
To ensure proper operation, be sure to fit the Hook (A) under the mounting hole.
8) Refit the removed parts in the reverse order of the removal procedure.
9) Plug in the icemaker or connect the power source.
13. BIN CONTROL SWITCH
1) Unplug the icemaker or disconnect the power source.
2) Remove the Top Panel and unscrew the Rear Panel.
3) Disconnect the Connector of the Bin Control Switch lead (black) covered with a
silicone hose and remove the lead wire from the Grommet.
4) Remove the Water Tank (see “16. WATER TANK”). The Bin Control Switch is
located as shown below when viewed from the front.
Fig. 16
Mounting Hole
Fig. 17
Separator Bin Control Switch
5) Pull down and remove the lead wire from the retainer on the right side of the Bin
Control Switch.
6) Hold both sides of the Bin Control Switch and pull it toward you.