Epson 10600 - Manual (Page 30)

1-15
Setting Up the Printer | 1-15
6. Hold the cartridge so the arrow mark on its left side is pointing toward
the printer. Insert the cartridge into the slot. Don’t force it.
7. Push the clamp back up into the locked position.
8. Repeat step 4 through step 7 for the other ink cartridges. When you’re
done, close the ink compartment cover.
The printer begins charging the ink delivery system. The Pause light on the
control panel flashes and the printer makes various sounds.
Charging takes about 10 minutes. Do not turn off the printer or interrupt
this process or you’ll use more ink than necessary. When the
Pause light
stops flashing and Paper Out appears on the control panel display, you’re
ready to load the roll paper.
Warning
If ink gets on your hands,
wash them thoroughly with
soap and water. If ink gets
in your eyes, flush them
immediately with water.
Note
If you can’t insert the
cartridge smoothly,
you may have the
wrong cartridge.
Caution
Do not turn off the
printer, change the
position of the paper set
lever, or open the lower
cover or ink compartment
cover while the printer is
charging ink.