Epson 10600 - Manual (Page 155)

5-26
5-26 | Maintaining and Transporting the Printer
Setting Up the Printer After Transportation
Setting up the printer after transporting it is almost identical to setting it up
for the first time. Whenever you set up the printer, see chapter 1.
• Don’t forget to remove the carriage locking bracket (if reinstalled).
• The first time you start printing after moving the printer, the print head
nozzles may be clogged. You may need to run a cleaning cycle (see page
5-4) and realign the print head (see page 5-7) to ensure good print
quality.
Moving the Printer on the Stand
When you need to move the printer a short distance, such as within the same
building or facility, you can roll the printer on its casters. Follow these steps:
1. Make sure the printer is turned off and the carriage is in the home
position (on the far right). If not, turn the printer back on, wait until the
carriage moves to the home position, then turn off the printer.
2. Disconnect the power cord and interface cables.
3. Make sure the printer covers are closed.
4. Fully insert the metal rods supporting the paper basket, then roll up the
basket so it doesn’t drag on the ground.
Caution
Do not roll the printer
on angled or uneven
surfaces.