Exabyte MAGNUM 1X7 LTO - Manual (Page 52)

36
P RODUCT M ANUAL 1012581
C
HAPTER
3—C
ONFIGURING THE
A
UTOLOADER
Setting the Ethernet Addresses
To set Ethernet addresses:
1. 1. 1. 1. At the Home screen, press , , , or to access the main menus.
If necessary, enter the operator panel password (see page 42 ).
2. 2. 2. 2. Press or until the Configuration menu appears:
3. 3. 3. 3. Press to see the menu selections.
4. 4. 4. 4. Press or until the following screen appears:
SNMP If you are using a network-based monitor/management
application other than the autoloader’s Remote Management
utility, you may need to identify the autoloader’s Simple
Network Management Protocol (SNMP) settings to the
application. These settings include:
ƒ
Read community string
ƒ Write community string
ƒ Broadcast community string
ƒ Trap address
ƒ Trap port
You can view and change these settings only through the
autoloader’s Remote Management utility. See Chapter 4 for
instructions.
FTP Interface The autoloader also includes an FTP interface that you can use
to transfer firmware files or create diagnostic listings. You can:
ƒ
Set up an FTP user name and password for this interface or
use the autoloader’s defaults
ƒ View and change the FTP settings only through the library’s
Remote Management utility
ƒ For instructions, see Chapter 4 .
For information about accessing the autoloader’s FTP interface
and using an FTP utility to upgrade firmware or obtain
diagnostic listings, see page 100 .
C h a n g e a
C o n f i g u r a t i o n
C h a n g e I P A d d r ?
D H C P I s O N
Table 3-5 Ethernet configuration options (continued)