Figure 7-9 – Exabyte MAGNUM 1X7 LTO User Manual
Page 113
O
CTOBER
2006
M
AGNUM
1
X
7 LTO A
UTOLOADER
97
R
EPLACING
THE
T
APE
D
RIVE
Half height tape drive: Place the brackets you removed from the original
half height tape drive on the new half height tape drive. Attach the
“thick” bracket on the right side of the tape drive–as viewed from the
back of the tape drive.
Note:
Make sure that the edges of the brackets are parallel to the edges of
the tape drive (not at an angle).
Full height tape drive: Place the brackets you removed from the original
full height tape drive on the new full height tape drive. See
for
the proper orientation. Attach the “thin” bracket on the right side of the
tape drive–as viewed from the back of the tape drive.
Note:
Make sure that the edges of the brackets are parallel to the edges of
the tape drive (not at an angle).
Figure 7-8 Attaching the brackets to a half height tape drive
Figure 7-9 Attaching the brackets to a full height tape drive
Right bracket
(thick)
Left bracket
(thin)
Right bracket
(thin)
Left bracket
(thick)
Back of
tape drive
Mounting
holes