Figure 7-5, Figure 7-6 – Exabyte MAGNUM 1X7 LTO User Manual
Page 111
O
CTOBER
2006
M
AGNUM
1
X
7 LTO A
UTOLOADER
95
R
EPLACING
THE
T
APE
D
RIVE
Full height tape drive: Note the orientation of the brackets, then using a
#1 Phillips screwdriver, remove the two screws from each of the
brackets attached to the tape drive (see
). Save the brackets and
screws to attach to the new tape drive.
I
NSTALLING
THE
N
EW
T
APE
D
RIVE
To install the new tape drive:
1.
1.
1.
1.
Remove the faceplate—Follow these steps to remove the faceplate.
a.
a.
a.
a.
Using a #2 phillips screwdriver, remove the three screws securing the
face plate to the tape drive chassis (see
).
Figure 7-5 Removing the brackets from the tape drive
Brackets
!
! !
!
Important
The replacement tape drive must be preconfigured for use in the
autoloader. Purchase replacement tape drives from Exabyte or an
Exabyte-approved supplier.
Figure 7-6 LTO full height tape drive with faceplate
Faceplate
(must be removed)
Screw
Screw
(one on each side)