Exabyte MAGNUM 1X7 LTO - Manual (Page 129)

O CTOBER 2006 M AGNUM 1 X 7 LTO A UTOLOADER 113
9
S
HIPPING THE
A
UTOLOADER
This chapter describes the process of returning the autoloader for service.
If you need to return the autoloader for service, first contact your service
provider. If your service provider instructs you to return the autoloader
directly to Exabyte, contact Exabyte Technical Support (see page iii ) to obtain a
Return Materials Authorization (RMA) number and the shipping address.
When you have the RMA number, follow these instructions.
P
REPARING THE
A
UTOLOADER FOR
S
HIPPING
To prepare the autoloader for shipping:
1. 1. 1. 1. Remove all of the cartridges from the autoloader. (See page 66 for
instructions.) Make sure that the tape drive does not contain a cartridge.
2. 2. 2. 2. Power off the autoloader.
3. 3. 3. 3. Remove the following from the autoloader:
Power cord
Ethernet cable
SCSI cables
SCSI terminator