Removing the autoloader from the rack, Figure 9-1, Figure 9-2 – Exabyte MAGNUM 1X7 LTO User Manual
Page 130
114
P
RODUCT
M
ANUAL
1012581
C
HAPTER
9—S
HIPPING
THE
A
UTOLOADER
R
EMOVING
THE
A
UTOLOADER
FROM
THE
R
ACK
If the autoloader is installed in a rack, remove it as described below.
1.
1.
1.
1.
From the back of the rack, use a #1 Phillips screwdriver to remove the two
screws that secure the autoloader to the rails (see
). Save the
screws.
2.
2.
2.
2.
From the front of the rack, slide the autoloader forward and out of the rack
(see
!
! !
!
Important
Do not ship the rack-mounting hardware if you are returning the
autoloader for service.
Figure 9-1 Removing the screws securing the autoloader to the rails
Figure 9-2 Removing the autoloader from the rack
Remove this screw
(one each side)