Connecting the autoloader to ethernet, Figure 2-9, Figure 2-10 – Exabyte MAGNUM 1X7 LTO User Manual
Page 34
18
P
RODUCT
M
ANUAL
1012581
C
HAPTER
2—I
NSTALLING
THE
A
UTOLOADER
shows how to connect the autoloader as the last device on a SCSI
bus.
5.
5.
5.
5.
Power on all of the peripheral devices on the SCSI bus.
6.
6.
6.
6.
Power on the autoloader as described on
.
C
ONNECTING
THE
A
UTOLOADER
TO
E
THERNET
The autoloader’s Remote Management utility (described in
) allows
you to remotely monitor operations when the autoloader is connected to an
Ethernet network. You can also create diagnostic listings and upgrade
autoloader firmware. For information about upgrading firmware and creating
diagnostic listings, see
.
To connect the autoloader to Ethernet using the provided cable:
1.
1.
1.
1.
Insert one end of the cable into the autoloader’s Ethernet port until you
hear it snap into place. The Ethernet port is located on the back of the
autoloader, as shown in
2.
2.
2.
2.
Connect the other end of the cable to the network or directly to the server
you plan to use to run the autoloader’s Remote Management utility or
upload firmware.
Figure 2-9 Connecting the autoloader as the last device on the SCSI bus
SCSI terminator
SCSI cable
Figure 2-10 Connecting the autoloader to an Ethernet network
Ethernet port