Enabling e-map, Deleting cameras from e-map, View log records – Elmo EDR-X216 User Manual
Page 36: E-map
Figure 23. E-Map
!( !0"
To enable E-Map, follow these steps:
1.
Click Enable E-Map to activate the E-Map on the main screen.
2.
Select the Position No. of the desired position of the specified Screen Division in which the E-Map will appear.
3.
Click Find > to select a bitmap to load into the E-Map.
4.
Click Go to copy the selected image to the drawing area.
5.
Select the camera Setting to set the position of the cameras, controls, and/or sensors
a.
Camera : Select the camera, then click the desired position for the camera on the E-Map.
b.
Control : Select the control, then click the desired position for the control on the E-Map.
c.
Sensor : Select the sensor, then click the desired position for the sensor on the E-Map.
6.
Click Save to save the setup settings.
. !0"
To delete cameras drawn on the E-Map, follow these steps:
1.
Click the Delete Camera, Control, Sensor checkbox.
2.
Click the camera, control or sensor you want to delete.
# %
28 - ELMO USER MANUAL 2003G