Panasonic Lumix GH5S Mirrorless Camera - Manual (Page 169)

169
7. Recording Motion Pictures
Applicable modes:
This unit automatically records time code during motion
picture recording.
• Time codes are not recorded on motion pictures recorded when
the [Rec Format] is set to [MP4] or [MP4 HEVC].
Setting the recording method of time code
> [Motion Picture] > [Time Code]
[Time Code
Display] Set whether or not the time code is displayed on the recording screen/
playback screen.
[Count Up]
Sets the time code count method.
[REC RUN]:
Counts the time code only when recording motion pictures.
[FREE RUN]:
Counts the time code even when not recording (including when this unit is
turned off).
• The setting is fixed to [REC RUN] in the following cases.
– When [Variable Frame Rate] is set
[Time Code
Value]
Sets the start point (starting time) for the time code.
[Reset]:
Sets to 00:00:00:00 (hour: minute: second: frame)
[Manual Input]:
Manually input hour, minute, second and frame.
[Current Time]:
Sets hour, minute and second to current time and sets frame to 00.
[Time Code
Mode]
Sets the time code recording method.
[DF] (Drop Frame):
The camera modifies the difference between recorded time and time code.
• Seconds and frames are separated by “.”. (Example: 00:00:00.00)
[NDF] (Non-Drop Frame):
Records the time code without drop frame.
• Seconds and frames are separated by “:”. (Example: 00:00:00:00)
• The setting is fixed to [NDF] in the following cases.
– When [System Frequency] is set to [50.00Hz (PAL)] or [24.00Hz
(CINEMA)]
– When the motion picture frame rate is set to [24p] in [Rec Quality]
[HDMI Time
Code Output]
Generates time code for images output through HDMI.
• [HDMI Time Code Output] can only be set in Creative Video Mode.
• The device screen may go dark depending on the connected device.
[External TC
Setting]
Sets up time code synchronization with an external device. (P170)
TC 00:01:30:00 TC 00:01:30:00
MENU