Panasonic Lumix GH5S Mirrorless Camera - Manual (Page 115)

115
5. 4K Photo and Drive Settings
Taking Pictures using Burst Mode
Applicable modes:
Pictures are taken continuously while the shutter button is pressed.
1
Set the drive mode dial to [ ].
2
Focus on the subject and take a picture.
• Hold down the shutter button fully to activate the Burst Mode.
∫ Setting the burst rate
¢ 1 This setting is applied when creating RAW files with [RAW Bit Size] set to [14bit].
¢ 2 Number of recordable pictures
¢ 3 When recording is performed under the test conditions specified by Panasonic.
The burst speed will become slower halfway. However, pictures can be taken until the
capacity of the card becomes full. Depending on recording conditions, the number of burst
pictures that can be taken will be reduced.
• The burst speed may become slower depending on the following settings.
– [Picture Size]/[Quality]/[Sensitivity]/Focus Mode/[Focus/Release Priority]
> [Rec] > [Burst Rate]
[H]
(High speed)
[M]
(Middle speed)
[L]
(Low
speed)
RAW
14 bit ¢ 1
RAW
14 bit ¢ 1
Burst speed
(pictures/
second)
AFS/MF 12 11 7 6
2
AFF/AFC 8 7 6 5
Live View
during Burst
Mode
AFS/MF None
Available Available
AFF/AFC Available
¢ 2
With RAW files 80 or more ¢ 3
Without RAW
files
600 or more ¢ 3
p
t AFS AFS
L
4:3
H
MENU