Canon EOS 90D DSLR Camera with 18-135mm Lens User Manual
Page 46
46
Charging the Battery
Upon purchase, the battery is not fully charged.
Charge the battery before use.
Recharge the battery on the day before or on the day it is to be
used.
Even during storage, a charged battery will gradually drain and lose its
capacity.
After recharging the battery, remove it and disconnect the charger
from the power outlet.
You can attach the protective cover in a
diff erent orientation to indicate whether the
battery is recharged or not.
If the battery is recharged, attach the protective
cover so that the battery-shaped hole <
> is
aligned over the blue sticker on the battery. If the
battery is exhausted, attach the protective cover in
the opposite orientation.
When not using the camera, remove the battery.
If the battery is left in the camera for a prolonged period, a small amount
of power current will keep being released, resulting in excess discharge
and shorter battery life. Store the battery with the protective cover
attached. Storing the battery when it is fully charged may lower the
battery performance.
The battery charger can also be used in foreign countries.
The battery charger is compatible with a 100 V AC to 240 V AC 50/60 Hz
power source. If necessary, attach a commercially available plug adapter
for the respective country or region. Do not attach any portable voltage
transformer to the battery charger. Doing so may damage the battery
charger.
If the battery becomes exhausted quickly even after having been
fully charged, the battery has reached the end of its service life.
Check the battery’s recharge performance (
battery.
o
After disconnecting the charger’s power plug, do not touch the prongs for
approx. 10 sec.
o
If the battery’s remaining capacity (
524) is 94% or higher, the battery will
not be recharged.
o
The provided charger cannot charge any battery other than Battery Pack
LP-E6N/LP-E6.