Epson C82324* - Manual (Page 39)

Enter one of the following hexadecimal values for C=
ethernet_type:
To configure the Ethernet Card for 802.3 only use 0001 through
05FF.
To configure the Ethernet Card for the Ethernet II type 8137, use
8137
To configure the Ethernet Card for both 802.3 and the Ethernet II
type 8137, use 0000.
If your network uses an Ethernet II type other than 8137 enter the
appropriate type for
C=ethernet_type.
Example: EPCONFIG 06400078 N=e C=0600 (sets Ethernet II type
600.)
Restore factory Defaults
EPCONFIG serial-number N=E VA
This command returns all of the values discussed in this chapter to
their factory defaults.
Because this command deletes the master file server, you must
reinstall the print server with EPSETUP to re-assign a master file
server.
Caution:
Once you send this command, you must wait for a message to
appear indicating the operation is complete before turning off the
printer. Turning off the printer before completion could erase the
interface’s memory; this could make the interface board unusable.
Changing the Configuration
2-15