Epson C82324* User Manual

Page 21

From the network or local drive where you copied the Ethernet

Card utilities, enter EPSETUP.

Select “Install New Ethernet Interface Card.”

Enter the eight-digit Ethernet Card serial number. The serial
number is located on the component-side of the interface

board. You should already have written it down on page

1-2 and in the space provided at the front of this manual

when you installed the Ethernet Card in the printer.

Select “Print Server Mode” to enter the operating mode. (For

instructions on installing as a remote printer, see “Installing
the Ethernet Card as a remote printer,” later in this chapter.)

It is recommended you rename the print server. The serial
number is the default name. Renaming is helpful for later

configuration needs, particularly if you plan to install more
than one Ethernet Card on your network. Enter up to 47
characters. The following characters are not allowed: Ctrl /

and space. A period (.) is allowed, if

Select the master file server.

Configure the Ethernet Card’s port. To successfully set up the

Ethernet Card, you must configure its LPT1 port by assigning

at least one queue to it.

Press ENTER

to select the Ethernet Card’s LPT1 port.

In the “Printer Port Configuration” screen, make changes to
port settings as desired. Note that you can turn

configuration report printing on or off.

Press

ENTER

to access the “Serviced Queues and File

Servers” list.

1-6

Installing the Ethernet Card