Epson C82324* - Manual (Page 33)

Using EPCONFIG
To use EPCONFIG, log in to the network with supervisor
privilege. You must log in to the master file server to successfully
complete the command, when indicated.
Correct EPCONFIG syntax is shown below, followed by an
explanation of command conventions.
EPCONFIG serial-number N=E [options]
EPCONFIG Information that must be entered
is shown in upper case. When
typing, you can use upper or
lower case: EPCONFIG does not
distinguish between cases.
serial-number
N=E
Words that appear in italics are
variables. Substitute the pertinent
information for the variable when
typing the command. You must
always enter the eight-digit
Ethernet Card serial number
when using EPCONFIG.
The serial number is located on
the component-side of the
interface board. You should
already have written it down on
page 1-2 and in the space
provided at the front of this
manual when you installed the
the Ethernet Card in the printer.
Since this interface card is for
Ethernet networks only, always
set this to N=E.
Changing the Configuration 2-9