Ɡ ɠ ɟ ɞ – Sony Signature Series NW-WM1ZM2 Walkman Digital Music Player User Manual
Page 8
8
MIC terminal (audio input terminal)
Input for commercially-available MIC or LINE
to connect an audio device.
Switch between MIC and LINE input as
indicated on “Connecting to commercially-
available microphones, etc.” (page 24).
Reset switch
Press the switch for 10 seconds or longer to
return to the factory default while in the
Power On or Standby status.
IR SELECT switch
Set the remote commander ID for receiving
the signal.
Use the same ID with the remote
commander being used.
Remote commander sensor
This is for the supplied remote commander.
SYSTEM SELECT switch
Used for selecting the video format to be
output from the HDMI and SDI OUT
terminals. When the SYSTEM SELECT switch
is set to 6, the setting can be changed
remotely in the OSD menu, Web App, or
VISCA/CGI commands.
CAMERA SETUP switches
Perform the camera setup.
CAMERA SETUP switch settings
SDI format/level settings
This setting is enabled when the video
format is 1920×1080/50p or 1920×1080/
59.94p.
When the SYSTEM SELECT switch is set to
6, the setting set on [VIDEO FORMAT] on
the OSD menu or [Format] under [Video
Out] on the Web App menu is applied.
To apply the settings, turn off the power and
back on again.
RESERVED
This switch is not used.
VISCA connect setting
This switch is used when VISCA and VISCA
over IP are used.
To apply the settings, turn off the power and
back on again.
Baud Rate settings of VISCA RS-422
communication
To apply the settings, turn off the power and
back on again.
19.5V
(DC power input) terminal
Connect the AC adapter (supplied).
Notes
• Do not use any AC adapter other than the
supplied AC adapter. Otherwise, a fire or
malfunction may occur.
• Do not connect the AC adapter and
PoE++(class8) power supply device at the
same time to avoid heat generation.
VISCA RS-422 IN terminal
Connect with a remote controller (not
supplied).
When you connect multiple cameras,
connect it to the VISCA RS-422 OUT terminal
of the previous camera in the daisy chain
connection.
VISCA RS-422 OUT terminal
When you connect multiple cameras,
connect it to the VISCA RS-422 IN terminal of
the next camera in the daisy chain
connection.
Switch No.
Setting items
1
SDI format/level settings
2
RESERVED
3
VISCA connect setting
4
Baud Rate settings of RS-422
for VISCA communication
ɡ ɠ ɟ ɞ
Switch state
SDI format/level
OFF
Level-A
ON
Level-B
Switch state
VISCA CONNECTION
OFF
Invalidates VISCA, VISCA over
IP
ON
Enables VISCA, VISCA over IP
Switch state
Baud Rate
OFF
9600 bps
ON
38400 bps