Sony ECM-X7BMP Electret Condenser Lavalier Microphone for UWP Transmitters - Manual (Page 86)

Specifications
86
Specifications
BVM-E251
Picture performance
Panel OLED panel
Picture size (diagonal)
623.4 mm (24 5 /
8
inches)
Effective picture size (H × V)
543.4 × 305.6 mm
(21 1 /
2
× 12 1 /
8
inches)
Resolution (H × V)
1920 × 1080 pixels (Full HD)
Aspect 16:9
Pixel efficiency
99.99%
Panel drive RGB 10-bit
Panel display frame rate
48 Hz, 50 Hz, 60 Hz 1)
See “Picture Frame Display” (page 97).
Viewing angle (Panel specification)
89°/89°/89°/89° (typical)
(up/down/left/right, contrast > 10:1)
Normal scan 0% scan
Native scan Mapping the pixels of the signal to the
panel to one-to-one mode, or
displaying an SD signal of non-
square pixels (the number of H
pixels of the signal system is 720 or
1440) or a 640 × 480 SD signal of
HDMI video by scaling processing
of doubling for the V direction and
correct aspect ratio for the H
direction and also optimizing and
displaying a picture by modifying
the aperture coefficient value, filter
coefficient value, etc.
Under scan 3% under scan
Over scan Mask of 5% over scan portion in the
normal scan
Color temperature
D55, D61, D65, D93, DCI 2) (Setting
possible in other color temperature)
Standard luminance (100% white signal input)
100 cd/m 2 (Preset1-Preset5)
48 cd/m 2 (Preset(DCI))
Color space (color gamut)
ITU-R BT.709, EBU, SMPTE-C, DCI-
P3 3) , E251 Native 4) , S-GAMUT/S-
GAMUT3 5) , S-GAMUT3.Cine,
ITU-R BT.2020
Warm-up time Approx. 30 minutes
To provide stable picture quality, turn
on the power of the monitor and
leave it in this state for more than 30
minutes.
1) 48 Hz and 60 Hz are compatible with a frame rate of 1/
1.001.
2) DCI: x=0.314 y=0.351
3) Chromaticity points of SMPTE RP 431-2, ITU-R BT.2020,
S-Gamut/S-Gamut3, and S-Gamut3.Cine are not covered
in full.
4) The BVM-E251 individual chromaticity points. The widest
color space setting of the signal reproduced by the BVM-
E251
(Typical)
5) For displaying the color space of the wide color space mode
which is available for the F65 or PMW-F55/F5 CineAlta 4K
Camera, etc.
Input
SDI BNC (×2)
Input impedance: 75 ohms unbalanced
Signal format: See “Available Signal
Formats” (page 89).
Sampling frequency
3G-SDI:
Y/Cb/Cr (4:2:2): 148.5 MHz/74.25
MHz/74.25 MHz
Y/Cb/Cr (4:4:4): 74.25 MHz/74.25
MHz/74.25 MHz
G/B/R (4:4:4): 74.25 MHz/74.25
MHz/74.25 MHz
HD-SDI:
Y/Cb/Cr (4:2:2): 74.25 MHz/37.125
MHz/37.125 MHz
SD-SDI:
Y/Cb/Cr (4:2:2): 13.5 MHz/6.75
MHz/6.75 MHz
Quantization
3G-SDI: 10bit/sample, 12bit/sample
HD-SDI: 10bit/sample
SD-SDI: 10bit/sample
Composite input (NTSC/PAL/PAL-M)
BNC type (×1)
1 Vp-p ±3 dB sync negative
HDMI HDMI (×1)
HDCP1.4 correspondence, Deep Color
correspondence
Signal format: See “HDMI” (page 93)
of “Available Signal Formats”.
Parallel remote RJ-45 (×1)
Serial remote (LAN)
Ethernet (10BASE-T/100BASE-TX)
RJ-45 (×1)
x y
R 0.681 0.319
G 0.189 0.724
B 0.141 0.051