Sony ECM-X7BMP Electret Condenser Lavalier Microphone for UWP Transmitters - Manual (Page 18)

Connecting Multiple Units with the LAN
18
Connecting Multiple Units
with the LAN
The controller controls up to 32 monitors. Up to three
controllers are connected to one monitor in single mode.
Notes
 The controller cannot control monitors in another
subnetwork.
 When you connect the BKM-16R, refer to the
operating instructions of BKM-16R.
1
Turn off the power switch of the monitor before
connecting the units.
2
Connect to the network by using a 10BASE-T/
100BASE-TX cable (shielded-type, sold separately).
Note
We recommend to use an optional switching hub
with auto selection function (AUTO MDI/MDI-X)
of a straight/cross cable.
3
Connect the output cable on the AC adaptor
supplied with the controller to the DC 12V
connector of the controller.
Note
When multiple units are connected, set for the LAN
before setting the NETWORK switch to LAN
(page 22).
4
Set the NETWORK switches of each monitor and
the controller to LAN.
NETWORK switch:
Set to LAN. NETWORK switch:
Set to LAN.
LAN (10/100)
connector
LAN (10/100)
connector
Switching hub
(recommended:
with AUTO MDI/
MDI-X function)
AC adaptor
(supplied with the
BKM-17R)
LAN (10/100)
connector
DC 12V
connector
Controller
(BKM-17R)
NETWORK switch:
Set to LAN.