Roland F701 88-Key Modern Digital Piano with Stand and Bench (White) - Manual (Page 29)

29
°
Convenient Functions
Loading/Saving Piano Setups
You can save your own piano settings in a USB flash drive, or load
them into the other digital piano.
* Settings can be loaded only into another piano of the same
model.
Settings that are saved
Setting Page
Speaker volume p. 6, p. 10
Headphone volume p. 7, p. 11
Ambience p. 20
Brilliance p. 20
Headphones 3D Ambience p. 20
Key Touch p. 20
Master Tuning p. 25
Temperament p. 25
Temperament Key p. 25
Hammer Response p. 25
Piano Tone settings p. 26
Volume Limit p. 34
Saving Piano Settings (Piano Setup Export)
1 . Connect your USB flash drive to the USB Memory
port.
2 . Press the [ ] button.
The button is lit, and the piano is in function mode.
3 . Turn the [ ] knob to access “Piano Setup Export”
screen, and then press the [ ] knob.
The Piano Setup Export screen appears.
4 . Rename the piano settings.
Select the character
which you want to
change
Turn the [ ] knob
Change the
character
Press the [ ] knob (confirm) 0
Turn the [ ]knob (change the
character) 0
Press the [ ]knob (back)
Insert one character Press the [ s ] button
Delete one
character
Press the [ 7 ] button
5 . Turn the [ ] knob to select the ( at the right
edge of the screen, and then press the [ ] knob to
confirm.
The settings are saved.
NOTE
Never turn off the power or remove the USB flash drive while the
screen indicates “Executing...”
6 . Press the [ ] button to exit function mode.
The button goes dark.
Loading Piano Settings (Piano Setup Import)
1 . Connect your USB flash drive to the USB Memory
port.
2 . Press the [ ] button.
The button is lit, and the piano is in function mode.
3 . Turn the [ ] knob to access “Piano Setup Import”
screen, and then press the [ ] knob.
The Piano Setup Import screen appears.
4 . Turn the [ ] knob to select the piano settings that
you want to load.
5 . Press the [ ] knob to confirm.
A confirmation message appears.
If you decide to cancel, press the [ ] button.
6 . Turn the [ ] knob to select “Yes,” and press the [ ]
knob to confirm.
The settings are loaded.
NOTE
Never turn off the power or remove the USB flash drive while the
screen indicates “Executing...”
7 . Press the [ ] button to exit function mode.
The button goes dark.