ProSoft Technology ICX30-HWC - Manual (Page 29)

ICX30-HWC ♦ Industrial Cellular Gateway Configuration Webpage
3G Cellular (M2M) User Manual
ProSoft Technology, Inc. Page 29 of 64
June 22, 2015
SNMP Description
Read Community Name Private: Read community string disabled
Public: Read community string enabled (default)
1st Trap Server IP IP address of the 1st trap server. The ICX30-HWC will report the
trap message this IP address
2nd Trap Server IP IP address of the 2nd trap server. The ICX30-HWC will report the
trap message this IP address
3rd Trap Server IP IP address of the 3rd trap server. The ICX30-HWC will report the
trap message this IP address
SNMPv3 Use SNMP version 3 reporting and features
Serial Port
The RS-232 serial port supports the Modbus and DF1 industrial communication
protocols. For either protocol, a master or slave(s) can be connected to the
ICX30-HWC serial port.
Serial Port Description
Baud Rate Baud rate used on the ICX30-HWC serial port
Data Data bits
Parity Parity
Stop Stop bits
Flow Control Flow control enable or disable
Characters Timeout Number of characters the ICX30-HWC will wait until a timeout is
determined from the device connected to the serial port.
Mode Disable, Modbus Point-To-Point, Modbus Point-To-Multipoint, DF1
(see below)
Modbus Point-To-Point Description
Server/Client Server = ICX30-HWC serial port is connected to a Modbus slave
Client = ICX30-HWC serial port is connected to a Modbus master
Remote ICX30 Server IP
Address (Client mode only) IP address of remote ICX30-HWC that is
connected to the Modbus slave.