ProSoft Technology ICX30-HWC - Manual (Page 25)

ICX30-HWC ♦ Industrial Cellular Gateway Configuration Webpage
3G Cellular (M2M) User Manual
ProSoft Technology, Inc. Page 25 of 64
June 22, 2015
WAN Configuration Description
Mode GSM or CDMA
APN Name Access point name provided by the carrier
Auto PIN Enable or Disable
PIN Code (Optional) PIN code to unlock SIM card
Carrier (CDMA only) Verizon, Sprint, Custom
Dialup Sequence to dial to establish a connection.
This field cannot be left blank when you A
PPLY
C HANGES . It will re-populate with a carrier-
assigned value upon reboot.
Periodic Reset Power cycle every X number of hours
User Name (Optional) User name for connection assigned
by the carrier upon reboot.
Password (Optional) Password for connection assigned
by the carrier upon reboot.
Authentication PAP - Password Authentication Protocol
CHAP - Challenge Handshake Authentication
Protocol
PAP & CHAP - Both are used
Roaming Helps ensure a mobile ICX30-HWC stays
connected
Data Plan Limit Enable or Disable
Start Day Starting day of billing of each month
Plan Size With Data Block enabled, the maximum
number of megabytes (MB) or gigabytes (GB)
of 3G data usage before 3G communications
are shut down until the next Start Day.
Data Block Enable or Disable
Ping Check Allows pinging two servers at set intervals. If
fail count is reached on both servers, the
ICX30-HWC disconnects from the WAN and
cycles power.
Interval Trial interval time in seconds
Fail Count Maximum number of ping failures before reset
1st Server IP address of the 1st server to ping
2nd Server IP address of the 2nd server to ping