ProSoft Technology 5202-DFNT-DFCM4 - Manual (Page 73)

DFCM ♦ ProLinx Gateway Reference
DF1 Master/Slave Driver Manual
ProSoft Technology, Inc. Page 73 of 88
October 15, 2010
8.7.1 Parameter Descriptions
[SECTION]/Item Range Description
[DF1 Master Port] Configuration Header for DF1 Master Port
Local Station ID: 0 to 255 This parameter specifies the local station ID for all DF1
messages sent from this master port. A value of 255 will
cause the slave address to be ignored and the address
issued in the master request packet to be used as the slave
ID.
Termination Type: BCC or
CRC
This parameter specifies the error checking for all DF1
messages. BCC or CRC
Baud Rate: This is the baud rate to be used on the port. Enter the baud
rate as a value. For example, to select 19K baud, enter
19200.
Ports 0, 1, 2 and 3
Baud Rate Parameter Value
110 110
150 150
300 300
600 600
1200 12 or 1200
2400 24 or 2400
4800 48 or 4800
9600 96 or 9600
14,400 14, 114 or 14400
19,200 19, 192 or 19200
28,800 28, 288 or 28800
38,400 38, 384 or 38400
Ports 1, 2 and 3 only
Baud Rate Parameter Value
57,600 57 or 576
115,200 115 or 1152
Parity: None,
Odd, or
Even
This is the Parity code to be used for the port. The values
are as follows: None, Odd, Even.
Data Bits: 7 or 8 This parameter sets the number of data bits for each word
used by the protocol.
Stop Bits: 1 or 2 This parameter sets the number of stop bits to be used with
each data value sent.
RTS On: 0 to
65535
This parameter sets the number of milliseconds to delay
after RTS is asserted before the data will be transmitted.
RTS Off: 0 to
65535
This parameter sets the number of milliseconds to delay
after the last byte of data is sent before the RTS modem
signal will be set low.