ProSoft Technology 5202-DFNT-DFCM4 - Manual (Page 29)

DFCM ♦ ProLinx Gateway DFCM Protocol Configuration
DF1 Master/Slave Driver Manual
ProSoft Technology, Inc. Page 29 of 88
October 15, 2010
6 DFCM Protocol Configuration
In This Chapter
[DF1 Pass-Through Port]....................................................................... 30
[DF1 Port x] ........................................................................................... 33
DF1 Master Configuration ..................................................................... 36
DF1 Slave Configuration ....................................................................... 37
[DF1 PORT x COMMANDS] .................................................................. 38
The following is excerpted from a full configuration file showing typical examples
of the DF1 port configurations. In this example, one port has been setup as a
master and the other as a slave. This example should serve only to give the
programmer an idea of how a CFG file is structured. Complete configuration files
are shipped on each unit and are available for download from the
www.prosoft-technology.com web site for each of the products. These files can
serve as an excellent starting point for any project.