ProSoft Technology 5202-DFNT-DFCM4 - Manual (Page 42)

Commands Supported by the Module DFCM ♦ ProLinx Gateway
Driver Manual DF1 Master/Slave
Page 42 of 88 ProSoft Technology, Inc.
October 15, 2010
In order to retrieve data from the modules database register 200, the remote
master would issue a command using the address N8:0. In order to interface with
database base register 405, the remote master would use the address N9:5. The
following table outlines the complete file emulation for the module:
Register Range File Start File End Content Size
0 to 4999 N7:0 N31:199 User Data 5000
5000 to 5009 N32:0 N32:9 Backplane Configuration 10
5010 to 5039 N32:10 N32:39 Port 1 Setup 30
5040 to 5069 N32:40 N32:69 Port 2 Setup 30
5070 to 5199 N32:70 N32:199 Reserved 130
5200 to 6399 N33:0 N38:199 Port 1 Commands 1200
6400 to 7599 N39:0 N44:199 Port 2 Commands 1200
7600 to 7700 N45:0 N45:199 Misc. Status Data 200
7800 to 7999 N46:0 N46:199 Command Control 200
8000 to 9999 N47:0 N56:199 Reserved 2000
All the data in the module is available to a remote host. This permits the host
device to remotely configure the module and view the status data.
7.1.1 Command Entry Formats
Note: The format of each command in the list depends on the function being executed. Refer to
the Reference chapter for a complete discussion of the DF1 commands supported by the module
and of the structure and content of each command.
The following table shows the structure of the configuration data necessary for
each of the supported commands.