PLANET WNAP-1260 - Manual (Page 33)

User’s Manual of WNAP-1260
-25-
Chapter 5. Quick Mode Configuration
Mode
Mode Available In
the Web
LAN1 (Management
IP Address)
LAN2
(DHCP)
DHCP
Server
Way of connecting to PC
Wireless Universal
Repeater (default)
Yes
Repeater
WDS
192.168.1.253
No
Disable Ethernet cable /Wireless
Bridge (default) No Disable Ethernet cable /Wireless
AP
Router
192.168.1.253
No Enable Wireless only
Client
Client (default) 192.168.1.253 No Disable Ethernet cable only
Table 4.1 IP information of AP/Repeater/Client modes of WNAP1260
Step 1 Set the three-way switch on the case of WNAP-1260 to the mode you want.
Step 2 Run the Internet Explorer (IE). Enter the management IP address of 192.168.1.253 and press
Enter. In the login window that is displayed, enter the user name and password (both admin),
and click Login.
Figure 5-1
Step 3 Configure parameters for the mode you selected.
Terminal devices can access the network through WNAP-1260 after you finish configuration by
following procedures in the sections below.
5.1. Repeater Mode Configuration
Step 1 Set the three-way switch on the side panel to Repeater after WNAP-1260 is powered on. Log
in to the configuration page after the system is started.