PLANET WNAP-1260 - Manual (Page 24)

User’s Manual of WNAP-1260
-16-
The following sections will introduce how to install and configure the TCP/IP correctly in Windows 7.
First, make sure your Ethernet Adapter is working, and refer to the Ethernet adapter’s manual if
needed.
4.4.1. Obtain an IP Address Automatically
If you are sure the DHCP server of WNAP-1260 is enabled (the default setting of Router Mode ), you
can set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on your PC. And then
the WNAP-1260 built-in DHCP server will assign an IP address to the PC automatically.
1) On the Windows taskbar, click the Start button, point to Control Panel, and then click it.
2) Under the Network and Internet icon, click on the View network status and tasks. And then
click Change adapter settings.
Figure 4-1
3) Right-click on the Wireless Network Connection, and select Properties in the appearing
window.